Fenix PD32(ULTIMATE EDITION)-XM-L (T6) NW, 740 lumens

Sometimes good is just not good enough, so we just upgraded one of our best selling models—PD32. We added a 740-lumen Burst Mode for you to drill through the darkness at extended distance. Color rendition and penetration power are also enhanced by the utilization of the latest Cree XM-L (T6) neutral white LED. To make this edition even better, each package also includes a customized diffuser tip.

◎Cree XM-L (T6) neutral white LED with a lifespan of 50,000 hours
◎Uses one 18650 rechargeable Li-ion battery or two 3V CR123A Lithium batteries
◎138mm (Length) x 24mm (Diameter)
◎74-gram weight (excluding the battery)
◎Digitally regulated output - maintains constant brightness
◎Low-voltage warning function to?remind you?to replace the battery
◎Reverse polarity protection guards against improper battery installation
◎Over-heat protection to avoid high-temperature of the surface
◎Anti-roll, slip-resistant body design
◎Tactical tail switch with momentary-on function
◎Side switch on the head
◎Made of durable aircraft-grade aluminum
◎Premium Type III hard-anodized anti-abrasive finish
◎Toughened ultra-clear glass lens with anti-reflective coating

Strobe and SOS
Press and hold the side switch for 1 second to enter into Strobe mode.
Press and hold the side switch for 3 seconds to enter into SOS mode.
When the flashlight is in Strobe mode or SOS mode, a single press on the side switch will return the flashlight to general lighting mode.

Intelligent Memory Circuit 
The flashlight will remember the last used general mode (it will not remember any flashing modes). So the next time you turn on the flashlight, it will light up at the last used general mode.   

Burst Output
When the flashlight is on Burst output, the LED is run at its maximum rated current and the battery is at its maximum discharge rate. Therefore the use of high quality battery is recommended.
PD32 (ULTIMATE EDITION) will accumulate a lot of heat when it is working in Burst output. To avoid overheating, the flashlight will automatically drop down into the turbo brightness level after working in Burst output for 3 minutes. If the non-stop Burst output is needed, just reset it again. Prolong use of the Burst output may reduce the life span of the flashlight or even cause permanent damage to the flashlight.

Low-voltage Warning Function
When the voltage level drops below the preset level, the flashlight will downshift to a lower brightness level. When the voltage level drops below the preset level of low output mode, the flashlight will blink three times every five minutes to?remind you?to replace the battery.


Over-heat Protection:
PD32 (ULTIMATE EDITION) will accumulate a lot of heat when it is working in Turbo output. To avoid overheating, the flashlight will automatically drop down into the high brightness level after working in Turbo output for 30 minutes. If the non-stop Turbo output is needed, just reset it again.