Fenix PD32(ULTIMATE EDITION)-XM-L (T6) NW, 740 lumens

Sometimes good is just not good enough, so we just upgraded one of our best selling models—PD32. We added a 740-lumen Burst Mode for you to drill through the darkness at extended distance. Color rendition and penetration power are also enhanced by the utilization of the latest Cree XM-L (T6) neutral white LED. To make this edition even better, each package also includes a customized diffuser tip.

◎Cree XM-L (T6) neutral white LED with a lifespan of 50,000 hours
◎Uses one 18650 rechargeable Li-ion battery or two 3V CR123A Lithium batteries
◎138mm (Length) x 24mm (Diameter)
◎74-gram weight (excluding the battery)
◎Digitally regulated output - maintains constant brightness
◎Low-voltage warning function to?remind you?to replace the battery
◎Reverse polarity protection guards against improper battery installation
◎Over-heat protection to avoid high-temperature of the surface
◎Anti-roll, slip-resistant body design
◎Tactical tail switch with momentary-on function
◎Side switch on the head
◎Made of durable aircraft-grade aluminum
◎Premium Type III hard-anodized anti-abrasive finish
◎Toughened ultra-clear glass lens with anti-reflective coating

Strobe and SOS
Press and hold the side switch for 1 second to enter into Strobe mode.
Press and hold the side switch for 3 seconds to enter into SOS mode.
When the flashlight is in Strobe mode or SOS mode, a single press on the side switch will return the flashlight to general lighting mode.

Intelligent Memory Circuit 
The flashlight will remember the last used general mode (it will not remember any flashing modes). So the next time you turn on the flashlight, it will light up at the last used general mode.   

Burst Output
When the flashlight is on Burst output, the LED is run at its maximum rated current and the battery is at its maximum discharge rate. Therefore the use of high quality battery is recommended.
PD32 (ULTIMATE EDITION) will accumulate a lot of heat when it is working in Burst output. To avoid overheating, the flashlight will automatically drop down into the turbo brightness level after working in Burst output for 3 minutes. If the non-stop Burst output is needed, just reset it again. Prolong use of the Burst output may reduce the life span of the flashlight or even cause permanent damage to the flashlight.

Low-voltage Warning Function
When the voltage level drops below the preset level, the flashlight will downshift to a lower brightness level. When the voltage level drops below the preset level of low output mode, the flashlight will blink three times every five minutes to?remind you?to replace the battery.


Over-heat Protection:
PD32 (ULTIMATE EDITION) will accumulate a lot of heat when it is working in Turbo output. To avoid overheating, the flashlight will automatically drop down into the high brightness level after working in Turbo output for 30 minutes. If the non-stop Turbo output is needed, just reset it again.

the most poweful Fenix flashlight- TK75

With the Fenix TK75, four 18650 rechargeable cells are stunningly transformed into 2600- lumen max output. Throwing 606m with an 80-degree plus beam angle lets the TK75 light up extended terrain.
On high at 1100 lumens, this compact Fenix flashlight pushes for four hours while the 400-lumen level stays the course at 12 hours runtime. ?The stainless crown, strobe and SOS functionality as well as the on-body dual switch system make the TK75 a trustworthy carry on search, caving and scouting missions. Mounted on a vehicle or stowed for emergency use, this light captures the proven performance found in every Fenix lighting product.

◎Uses Cree XM-L(U2) LED with a lifespan of 50000 hours
◎Uses four18650 rechargeable Li-ion batteries
◎ 185mm (Length) x 52.5mm (Diameter) x 87.5mm (Head)
◎ 510-gram weight (excluding batteries)
◎ Digitally regulated output - maintains constant brightness
◎Low-voltage warning function to alert users to replace the batteries
◎ Reverse polarity protection guards against improper battery installation
◎ Dual button switch system in the front for quick switching
◎ Made of durable aircraft-grade aluminum
◎ Premium Type III hard-anodized anti-abrasive finish
◎ Toughened ultra-clear glass lens with anti-reflective coating

Operation Instruction

Two buttons control the TK75’s operation. The right side button with a power source mark is for ON/OFF. The left side button with a recycling mark controls MODES & BRIGHTNESS LEVELS.
A single press on the power switch turns the TK75 on or off.
With the flashlight on, a single press on the mode switch switches the light between the Turbo→Low→Mid→High→brightness levels;
To enter into the strobe mode, press and hold the side mode switch for about one second. It will flash between 6Hz and 15Hz every two seconds.
To enter into SOS mode, press and hold the side mode switch for about three seconds.
While in strobe or SOS mode, a single press on the side mode switch returns the TK75 to non-flashing mode where brightness can be adjusted.
Whether it is on or off, the light will enter into strobe or SOS mode if the mode switch is pressed and held.
With advanced circuitry, the TK75 will remember the last-used brightness level (not flashing modes) the next time it is turned on.

Fenix TK22(U2, 650 lumens, lossless orang peel reflector)

Fenix TK22 features a powerful, tough, durable, and fully waterproof design intended for harsh outdoor conditions. Powered by large capacity 18650 Lithium battery, safe 16340 LiFePO4 battery or frost-resistant CR123A Lithium battery, the light makes a perfect combination of extreme brightness and ultra long runtime. The innovative side switch on the head flows between four brightness levels and strobe mode，plus the advanced constant brightness technology and waterproof to IPX-8 standard, TK22 will be your reliable partner when searching ，rescuing, etc.
◎ Uses Cree XM-L (U2) LED with a lifespan of 50,000 hours
◎ Uses one 18650 rechargeable Li-ion battery or two 3V CR123A Lithium batteries
◎147mm (Length) x 25.4mm (Diameter) x 40mm (Head)
◎ 157-gram weight (excluding the battery)
◎ Digitally regulated output - maintains constant brightness
◎Low-voltage warning function, to remind the users of battery replacement when in low voltage
◎ Reverse polarity protection, to protect from improper battery installation
◎ Anti-roll, slip-resistant body design
◎ Tactical tail cap switch with momentary-on function
◎ Mode switch button in the front, one press for brightness selection
◎ Made of durable aircraft-grade aluminum
◎ Premium Type III hard-anodized anti-abrasive finish
◎ Toughened ultra-clear glass lens with anti-reflective coating

Fenix E50( XM-L neutral white, 780 LUMENS)

Powered by two 18650 batteries or four CR123A batteries, E50 delivers a 780-lumen neutral white beam and runs for 80 hours in low mode. With the adjustable battery tube and four brightness levels, you can easily customize the size, output and runtime of the flashlight to best suit your adventure.
◎ Cree XM-L (T6) neutral white LED with a lifespan of 50,000 hours
◎ Use two 18650 batteries or four CR123A batteries
◎ 207mm (Length) x 40mm (Diameter)
◎ 146.6-gram weight (excluding batteries)
◎ Digitally regulated output - maintains constant brightness
◎ Reverse polarity protection guards against improper battery installation
◎ All-function switch on the head, simple and convenient operation 
◎ Made of durable aircraft-grade aluminum
◎ Premium Type III hard-anodized anti-abrasive finish

◎ Toughened ultra-clear glass lens with anti-reflective coating